Star Micronics 150 manual Vertical Control, Character

Programmer's Guide			PcOS Series 150	Configuration Mode
	General					Recommendation
	10 cpi	The 10 cpi command can be prevented from being acted			on.
		If set to disable, the printer will ignore the 10 cpi command
		(DC2).
		Active				￿
		Disabled
	Print Illegal
	Commands
		No				￿
		Yes
	Print Zone	There are two print zone settings.
		Normal (2.40 inch)				￿
		Wide (2.83 inch)
	Series 50	The Ithaca Series 50 Printer uses several commands that are
	Compatibility	not supported by the Series 150 Printer. In some cases, these
		commands have different functions in the Series 150 Printer.
		If this option is set, the Series 50 commands are activated
		and overlapping Series 150 commands deactivated.
		Off				￿
		On
	Vertical
	Control
	Line Spacing	The line spacing can be defaulted to 6 or 8 lpi.
		6 lpi
		8 lpi				￿
	Auto Line	An auto line feed feature can be set as a default where all
	Feed	[CR]’s will have a [LF] added. If auto line feed is set to on,
		this feature is activated.
		Off				￿
		On
	Auto Carriage	An auto carriage return feature can be set as a default where
	Return	all [LF]’s will have a [CR] added. If auto carriage return is set
		to on, this feature is activated.
		Off				￿
		On
	Form Length	The default form length can be set from 3 to 17 inches. This
		configuration affects how the [FF] command operates.
		3 to 17 inches				11
	Line Feeds	The number of line feeds before a cut operation is performed
	Before Cut	can be set from 0 to 15 lines.
		0 to 15 lines				0
	Character
	Print Mode	The default print mode can be set to Draft, Utility, NLQ
		Courier, or NLQ Sans Serif. In most cases, Draft or Utility
		mode will be the default selections.
		Draft				￿
		Utility
		NLQ Courier
		NLQ Sans Serif
	Character	The default print pitch can be set to 8, 10, 12, 15, 17.1, 20, or
	Pitch	24 characters per inch.
		8 cpi
		10 cpi
		12 cpi
		15 cpi
		17.1 cpi				￿
		20 cpi
		24 cpi

12/14/99 Rev G Page 97