Star Micronics 150 manual Xon/Xoff

Programmer's Guide				PcOS Series 150	Configuration Mode
		5 – Swedish I
		6 – Italian
		7 – Spanish I
	General					Recommendation
		8 – Japanese
		9 – Norwegian
		10	– Danish II
		11	– Spanish II
		12	– Latin American
		13	– French Canadian
		14	– Dutch
		15	– Swedish II
		16	– Swedish III
		17	– Swedish IV
		18	– Turkish
		19	– Swiss I
		20	– Swiss II
		64	– Publisher
	Zero	The zero character can be configured to be unslashed or
	Character	slashed in all character sets except IBM 64 and 65 which
		override this setting.
		Unslashed
		Slashed				￿
	Interface	The Series 150 Printer supports either a serial or parallel
		communication link.
	Parallel Mode	This setting should not be changed except from parallel to
		IEEE 1284.
		Parallel
		IEEE 1284
	Parallel Link	The parallel option features define how the strobe, busy, and
	Options	acknowledge signals operate. In normal mode, the printer
		follows the standard (Centronics) parallel port conventions.
		With Options 1 and 3, the acknowledge and busy signals
		change at the same time. This is sometimes referred to as
		Ack-after-Busy. Options 2 and 3 force busy high on the rising
		edge of strobe. This is sometimes referred to as Busy-while-
		Strobe timing. In all cases, the data is latched on the rising
		edge of the strobe. In most cases, the normal timing mode
		will give the best and most universal results.
		Normal Ack-while-Busy				￿
		Option 1 Ack-after-Busy
		Option 2 Ack-while-Busy
		Option 3 Ack-after-Busy
	Parity	The serial mode parity can be set to none, odd, or even.
		None				￿
		Odd
		Even
	Bit Data	The serial bit format can be set to 8 or 7.
		8				￿
		7
	Protocol	The flow control protocol/serial link can be set to Ready/Busy
		or XON/XOFF. If XON/XOFF is selected, Ready/Busy also
		functions.
		Ready/Busy				￿
		XON/XOFF

12/14/99 Rev G Page 101