Programmer’s Guide

PcOS Series 150

Cash Drawer Interface

Chapter 11:

Cash Drawer Interface

Interface Description

The Series 150 Printer supports dual cash drawers with status. The driver in the printer is capable of supplying 24 VDC at up to 1.5 amps and 250 milliseconds. The Series 150 Printer defines cash drawer closed as switch open. If the drawer is disconnected, it will be viewed by the printer as closed. Since the printer does not act on the cash drawer status, the application can interpret cash drawer status any way it wants.

Interface Connectors

There are two cash drawer connectors. One is configured as Cash Drawer 1, the other as Drawer 2. The pin out is as follows:

Function

Drawer 1

Drawer 2

Drawer Drive +

Pin 4

Pin 4

 

 

 

Drawer Drive -

Pin 5

Pin 1

 

 

 

Status Signal

Pin 2

Pin 2

 

 

 

Status Ground

Pin 3

Pin 3

 

 

 

Frame Ground

Pin 6

Pin 6

 

 

 

No Connect

Pin 1

Pin 5

 

 

 

Table 16 Ithaca cash drawer connector

Pin 1

Note: Cash Drawer 2 can be factory configured to be the same as Drawer 1.

Function

Drawer 1

Drawer 2

Drawer Drive +

Pin 4

Pin 4

 

 

 

Drawer Drive -

Pin 2

Pin 5

 

 

 

No Connect

Pin 5

Pin 2

 

 

 

Status Signal

Pin 3

Pin 3

 

 

 

Status Ground

Pin 6

Pin 6

 

 

 

Frame Ground

Pin 1

Pin 1

 

 

 

Table 17 Epson/Axiohm cash drawer connector

Function

Drawer 1

Drawer 2

Drawer Drive -

Pin 2

Pin 2

 

 

 

Drawer Drive +

Pin 3

Pin 3

 

 

 

Status Signal

Pin 6

Pin 6

 

 

 

Frame Ground

Pin 1

Pin 1

 

 

 

No Connect

Pin 4

Pin 4

 

 

 

No Connect

Pin 5

Pin 5

 

 

 

Table 18 Star cash drawer connector

12/14/99

Rev G

Page 127

Page 137
Image 137
Star Micronics 150 manual Chapter Cash Drawer Interface, Interface Description, Interface Connectors, Function Drawer