Star Micronics 150 manual Epos Deviations

Control Codes		PcOS Series 150	Programmer's Guide
EPOS Deviations
Function	Set print direction
ASCII	[ESC] T <n>
Description	The Series 150 Printer does not implement page mode. This command
	uses the normal rotated print format procedures. See [ESC] r <n> in
	normal mode.
	Note: EPOS reverses Modes 1 and 3.
Function	Print graphics
ASCII	[ESC] * <m> <n>1 <n>2
Description	The Series 150 Printer defines the extended graphic modes. Mode 4 is
	normally 80 dpi. The Series 150 Printer does not support 80 dpi. If
	Mode 4 is selected, 72 dpi will be used.
	Print n1 + 256 * n2 bytes of graphics where m specifies the density.
Where m	0	Single-density graphics		60 dpi
	1	Double-density graphics		120 dpi
	2	Double-density half-speed graphics		120 dpi
	3	High-density graphics		240 dpi
	4, 5	CRT II screen		72 dpi
	6	CRT I screen		90 dpi
	7	Dual plotter		144 dpi
Function	Turn 90° clockwise font ON/OFF
ASCII	[ESC] V <n>
Description	The Series 150 Printer uses the rotated 90° font to implement this
	command. If one dot spacing is selected, ten cpi is used. If 1.5 dot
	spacing is selected, eight cpi is used.
Function	Select print paper
ASCII	[ESC] c 0 <n>
Description	The Series 150 Printer uses this command to select a print station. The
	Series 150 Printer does not keep track of different settings for each
	mode. If a specific print mode is required, it must be respecified.
Function	Select print paper for setting
ASCII	[ESC] c 1 <n>
Description	The Series 150 Printer does not keep track of different settings for
	each mode. If a specific print mode is required, it must be respecified.
Function	Select detectors to stop printing
ASCII	[ESC] c 4 <n>
Description	The Series 150 Printer does not stop at the end of forms. The
	application must keep track of the form length.

Page 72 Rev G 12/14/99