Control Codes PcOS Series 150 Programmer's Guide
EPOS Codes

Page 70 Rev G12/14/99

[ESC] < Return home (not necessary with the Series
150 printer).
[ESC] = Not the same Select peripheral device (Pass through).
[ESC] ? Ignored Cancel user-defined characters.
[ESC] @ Initialize printer.
[ESC] B <n>1 <n>2 <n>3
... <n>i 0 Extension Set vertical tab stops.
[ESC] C <n> Similar Set form length.
[ESC] D <n>1 <n>2
<n>3 ... <n>i 0 Extension Set horizontal tab stops.
[ESC] E <n> Turn emphasize mode ON/OFF.
[ESC] G <n> Turn double-strike mode ON/OFF.
[ESC] J <n> Print and feed.
[ESC] K <n> Not implemented Print and reverse feed.
[ESC] M <n> Select character font.
[ESC] Q <n> Set right margin in characters.
[ESC] R <n> Select International Character Set.
[ESC] U <n> Turn unidirectional mode ON/OFF.
[ESC] V <n> Similar Turn 90° clockwise mode ON/OFF.
[ESC] [ <m> <n> Select code page/print features (same as
normal mode).
[ESC] \ <nL> <nH>Set relative print position.
[ESC] ^ ... Set Epson 9-pin bit image.
[ESC] a <n> Set left, center, or right justify.
[ESC] b <n> Print bar code (same as normal mode).
[ESC] c <n> Similar Select station. See description below.
[ESC] d <n> Feed <n> lines.
[ESC] e <n> Not implemented Print and reverse feed.
[ESC] f <t1> <t2> Similar Set wait time. See description below.
[ESC] I Set full cut.
[ESC] l <n> Set left margin in characters.
[ESC] m Set partial cut.
[ESC] p <m> <t1> <t2> Similar Generate pulse. See description below.
[ESC] q Release form.
[ESC] t <n> Select Character Code Table (may vary from
Epson Select Code).
[ESC] u <n> Return status of cash drawer (Serial and IEEE
1284 only).
[ESC] v Extension Return null byte to host.
[ESC] x <n> Extension Set print font (same as Normal [ESC] I <n>).
[ESC] { <n> Turn upside down print ON/OFF.
[ESC] ~ <n> Extension Test mode diagnostic commands.
[GS] ! Select character size.
[GS] I <n> Transmit specified ID (different than Epson).
[GS] L ... Set left margin in 1/160 inch.
[GS] W ... Select printable area in 1/160 inch.
[GS] h <n> Extension Set bar code height.
[GS] k <m> ... <0> Extension Print bar code.