Star Micronics 150 manual Configuration Mode PcOS Series, Dtr/Rts

Configuration Mode PcOS Series 150 Programmer's Guide

General			Recommendation
Baud Rate	The bit rate of the printer can be set to 19200, 9600, 4800,
	2400, 1200, 600, or 300 bits per second. The same bit rate is
	for send and receive.
	19200 bits per second
	9600 bits per second		￿
	4800 bits per second
	2400 bits per second
	1200 bits per second
	600 bits per second
	300 bits per second
SSD Signal	The serial port SSD signal can be configured to provide flow
	control. If SSD is active, it will toggle to false when the buffer
	is full. Note: SSD flow control is only available on the optional
	25-pin serial interface.
	Not used		￿
	Active
DTR/RTS	The serial port DTR and/or RTS signal can be configured to
Signal	provide flow control. If DTR is configured as the flow control
	signal, it will toggle to false when the buffer is full, RTS will
	not.
	Not used
	DTR flow
	RTS flow
	RTS and DTR flow		￿
CTS Signal	If active, a false CTS will prevent the printer from sending any
	data to the host.
	Not used		￿
	Active
DSR Signal	If active, a false DSR signal will prevent the printer from
	accepting any data.
	Not used		￿
	Active
Off-line	The printer can be set to active (normal operation) or buffer
	full only mode. In active mode, the printer goes off-line when
	it runs out of paper. In buffer full only mode, the printer only
	goes off-line if a fault is detected, and the buffer full operates
	normally.
	Active		￿
	Buffer full only
Microsoft	This option allows Windows to query the printer as to its
Windows	identity. The printer supports this in parallel and serial mode.
Plug and Play	This option presets several of the link modes.
	Serial mode	RTS flow control
	Parallel mode	IEEE 1284
	Off		￿
	On
Multidrop	If set to an address, the multidrop feature will be activated at
	power up.
	Off		￿
	A device
	B device

Page 102 Rev G 12/14/99