Star Micronics ND-10/15 user manual Slide the I/F board into the slot

nInstalling the interface board

Interface cover

board

Figure 1-7.Slide the I/F board into the slot.

A parallel interface board comes standard with your printer. In addition, there are two optional interface (I/F) boards: a serial interface board that lets you connect to a serial (RS-232C) computer port; and the other board contains extra buffer memory for parallel output. All three boards are installed the same ,way.

To install or change an I/F board, turn off the power and turn the printer around. Notice the snap-on cover at the left end. Take it off by sliding it upwards.

Fit the I/F board into the side slots and slide it all the way down (don’t force it). Make sur.e that the board connector is seated snugly in its socket. Put the cover back on and connect the cable from your computer - you’re ready to go.