Star Micronics ND-10/15 user manual Adjusting the Print Head

16

9. Set the release lever to the auto-feed setting. The printer will advance the paper automatically.

10.Feed the paper through the slot in the printer cover.

11.Install the paper guide on the printer. See Figure 2-10 for details. When used with sprocket-feed paper, the guide is turned around and laid flat on top of the printer as a paper separator. Make sure that the tabs on the guide fit into their receivers.

Figure Z-10.Ready to load the sprocket-feed paper. Note the reversed

position of the paper.

ADJUSTING THE PRINT HEAD

The distance between the print head and the platen must be adjusted to accommodate papers of different thicknesses. To make this adjustment, move the adjustment lever, which is under the printer cover and immediately in front of the release lever (Figure 2-l 1). Pulling the adjustment lever towards you will widen the gap; pushing it away from you will narrow the

gap.