Install Interface Cables at Host
3-54 Sixth Edition 95741
■Install Interface Cables at Host
Install the free end of the interface cable (Fibre Channel or SCSI) to the
applicable hub, switch, or host.
CAUTION:
For SCSI cables, remove power from the 9840 Tape Drive before
connecting to the host.
Note: If you are attaching to a 50-pin SCSI bus, an adapter is required (part
number 10148010).
■Manually Load Cartridges
Test each installed drive to ensure it loads and unloads a cartridge correctly.
■Return System to Operator
After installation and testing of the 9840 Tape Drive. Follow these steps before
you turn the unit over to the customer:
1. Place the drive online (see Chapter 4, “Getting Started”).
2. Return to the 9738 library installation documentation and complete the
library installation, if applicable.
Note: The 9738 library configuration must be updated to identify 9840
Tape Drives.
3. If applicable, provide the operator with training on the 9840 Tape Drive.
4. If applicable, provide training on placing a service call.