Rack
3-36 Sixth Edition 95741
4. Insert a nut plate at the front vertical frame members in holes 10 and 11 using two screws
(see the figure below).
Note: Only turn the screws until a few threads are in the nut plate. In a later step, the
slide-rail assembly will be inserted between the nut plate and the frame member.
5. Insert a nut plate at the rear vertical frame members in holes 10 and 11 using two screws.
6. Install slide rails by inserting them between the nut plates and vertical frame members.
7. Repeat Step 1 through Step 6 for each additional drive tray you will be installing.
8. Proceed to “Rack-mountable Tray” on page 3-38 if you will not be installing CSL trays.
1. Hand tool
2. Captive nut
E53321
1
2