95741 Sixth Edition 3-21
Desktop Units
Install Host Interface Cables
The 9840 Tape Drive supports Fibre Channel and SCSI interfaces. This section
contains:
•“Fibre Channel Cables (Desktop/CSL)”
•“SCSI Cables (Desktop/CSL)” on page 3-23
Fibre Channel Cables (Desktop/CSL)
Use the instructions below to install the Fibre Channel cables:
CAUTION:
Cable damage. Fiber optic cables are easily damaged. Follow the
guidelines in Chapter 2, “Safety and Handling” to prevent damage to the
cables.
1. Mark each Fibre Channel cable with the device address and port.
2. Route the interface cable(s) from near the host, hub, or switch to the drive/CSL.
Note: Do not attach either end of the cable(s) at this time.
3. Remove the rubber port plug from the selected drive/CSL port and clean the port.
Note: If you are unfamiliar with the cleaning procedure, see “Clean Fibre Channel
Components” on page 8-4.
4. Remove the interface cable connector covers and clean the cable ends with wipes.
Note: If you are unfamiliar with the cleaning procedure, see “Clean Fibre Channel
Components” on page 8-4.