95741 Sixth Edition 3-27
Rack
Installation Overview
CAUTION:
Equipment damage. The RACK001 is only intended for the 9840 drive or
CSL trays. Any other equipment plugging into the rack power strip must
be approved by StorageTek and the appropriate safety agencies.
Figure 3-8 provides an overview of the rack installation and the location of the
stablizer.
The rack ships with the following items installed:
•A 2 EIU (88.5 mm/3.48 in.) filler at the top of the rack
•Five 4 EIU (177 mm/6.97 in.) fillers in drive tray locations two through six
•A 9 EIU (398 mm/15.7 in.) filler at the bottom of the rack
•Fan tray at the rear of the rack
•Power Distribution Unit (power strip) at the rear of the rack
There is an opening below the upper filler where the first drive or CSL tray will
be installed. To install additional trays, you must remove the filler plates.
Figure 3-8. Rack Installation Overview
1. Stabilizer
C53253
1