95741 Sixth Edition 5-17
Modes of Operation
Mount Message
When the CSL receives a mount message from the host, one of the following
occurs:
•If the drive is empty and the feed channel contains a cartridge which hasn’t
been previously loaded, the cartridge loads into the drive.
•If the drive and the feed channel are empty, but at least one cartridge is
available in the input bin, then the cartridge loads into the drive.
•Refer to “Priority Mount Mode” on page 5-20 to physically mount a priority
cartridge directly into the CSL.
Unload Message
When the CSL receives an unload message, the cartridge in the drive moves to
the feed channel. The CSL sequences as follows:
•If the output bin is not full, the cartridge is placed into the output bin.
•If the output bin is full, the cartridge remains in the feed channel, and the
operator indicator blinks until the cartridge is removed and the Start switch
is pressed.
Note: Refer to “Cartridge Removal from Feed Channel” on page 5-22 to
remove a priority mounted cartridge from the feed channel.
•If a mount has been pre-queued then, if possible, the next cartridge is
mounted with only one cartridge shift operation.
Place CSL in System Mode
1. Press the Autoload Mode switch until the system indicator illuminates.
2. Press the Start switch to set the System mode.
3. Load up to seven cartridges in the input bin.
4. Press the Start switch.
Note: The CSL does not respond to the Start switch if a cartridge is not in
the input bin of the loader.
5. Unload the output bin when necessary.