Subaru Robin Power Products RGX5500, RGX3500, RGXI 800, RGX2400 M8 X 18mm bolt . . . . . .4 pcs

104 ASSEMBLY PROCEDURES

104-l FRONT COVER

Attach the front cover to the engine main bearing cover. Match the faucet joint and tighten the bolts.

M8 X 18mm bolt . . . . . .4 pcs.

M8 spring washer . . _. -4 pcs. Tightening torque : 120 - 140 kg-cm

8.7 - 10.1 ftlbs.

104-2 ROTOR

(1)Wipe off oil, grease and dust from the tapered portion of engine shaft and matching tapered hole of rotor shaft.

(2)Mount the rotor to the engine shaft. Tighten the through bolt.

Apply a wrench on the through bolt and hit wrench handle clockwise with a hammer to tighten.

If an impact wrench is available, use it. Tightening torque :

RGX1800,2400 : 115 - 135 kg-cm

8.7- 10.8 ftlbs.

RGX3500,5500 : 230 - 250 kg-cm

16.6- 19.5 ftlbs.

104-3 STATOR

(1)Put the stator in the rear cover setting the four grooves on the side of stator with thread holes of the rear cover.

Tighten the four bolts tentatively to check if the grooves and thread holes are aligned correctly. (See Fig-lo-25.)

(2)Remove the four bolts.

Fig. 10-23

Fig. lo-24

@BOLT . . . . . .4pcs.

60SPRlNG WASHER

. . . . . . . . . . 4 pa.

60 WASHER . . . . 4 PCS.

Fig. 10-25

- 61 -