Attach the end cover to the rear cover.
M6 X 8mm flange bolt
2.9 - 4.3 ftlbs.
Fig.
(1)Attach the mount rubbers to the frame.
Insert the setting tongue of mount rubber into the hole on the frame and tighten the nut from
the bottom of the frame.
M8 flange nut . .. . .. .. ... ...... .. .. . 4 pa* Tightening torque : 120 : 140
8.7- 10.8
Fig.
NOTE: The mount rubbers are selected to reduce vibration most effectively by model and its frequency.
Be sure to use the correct mount rubber for your generator.
Although mount rubbers have the same appearance, their characteristics are different.
(2)Attach the 5~$terminal of the grounding wires (green/yellow) to the unpainted thread hole of the frame base plate using a 5 mm brass screw.
;n
- 64 -