(3)Install the engine and alternator assembly into. the frame.
Put the engine and alternator assembly into the frame from the side of it.
Tighten the nuts over the mount rubber bolts to fix.
M8 nuts
Tightening torque : 120 - 140
8.7- 10.1 ftlbs.
Fig.
NOTE : When tightening the nuts, slightly lift the engine and‘altemator assembly so that the weight is not applied to the mount rubbers.
(4) Attach the side plate frame.
M6 X10 mm bolt
Tightening torque : 40 - 60
Fig.
Mount the control box assembly to the frame.
Refer to Section
(1) Attach the 4t$ terminal of the grounding | wires to the rear panel of the control box. | |
M4nut | 1 pee. |
|
(2)Connect the wires drawn out from the stator to the wires from the control box. Connect the oil sensor wires at the same time.
NOTE : Connect the wires of the same color.
- 65 -