4.Modify the default IP address that will be used in your network. Use the addr command to modify the network configuration of the terminal concentrator. Use the addr
monitor:: addr
Enter Internet address [0.0.0.0]:: 192.212.87.62
Internet address: 192.212.87.62
Enter Subnet mask [255.255.0.0]:: 192.255.255.0
Subnet mask: 192.255.255.0
Enter Preferred load host Internet address [<any host>]:: 0.0.0.0
Preferred load host address: <any host>0.0.0.0
Enter Broadcast address [0.0.0.0]:: 192.212.87.255
Broadcast address: 192.212.87.255
Enter Preferred dump address [0.0.0.0]:: 0.0.0.0
Preferred dump address: 0.0.0.0
Select type of IP packet encapsulation (ieee802/ethernet) [<ethernet>]:: ethernet
Type of IP packet encapsulation: <ethernet> :: ethernet
Load Broadcast Y/N [Y]:: N
Load Broadcast: N
monitor:: addr
Ethernet address (hex):
Internet address: 192.212.87.62
Subnet masks: 192.255.255.0
Preferred load host address: <any host>
Broadcast address: 192.212.87.255
Preferred dump address: 0.0.0.0
Type of IP packet encapsulation: <ethernet>
Load Broadcast: N
monitor:: sequence
Enter a list of 1 to 4 interfaces to attempt to use for downloading code or upline dumping. Enter them in the order they should be tried, separated by commas or spaces. Possible interfaces are:
Ethernet: net
SELF: self
Enter interface sequence [net]:: self
Interface sequence: self
5.Copy the Ethernet address entered above for the terminal concentrator, and add it to “Ethernet IP Address Worksheet” on page 8 for later reference when configuring the cluster.
