3.Configure the Sun StorEdge T3 array shared disk storage, using the Solstice DiskSuite software.

Solstice DiskSuite configuration involves creating disksets, metadevices, and file systems. (Refer to the included Solstice DiskSuite documentation.)

4.Select a quorum device to satisfy failure fencing requirements for the cluster. (Refer to the included Sun Cluster 3.0 documentation.)

5.Install and configure the highly available application for the cluster environment. (Refer to the Sun Cluster 3.0 documentation.)

6.Establish resource groups, logical hosts, and data services to enable the required application under the Sun Cluster 3.0 infrastructure. (Refer to the Sun Cluster 3.0 documentation.)

Your customized Cluster Platform 4500/3 is completed.

Cluster Platform 4500/3 Recovery

The recovery CDs enable you to replace the factory-installed Cluster Platform 4500/3 software environment on the management server in the event of a system disk failure.

Caution Initiate a recovery only at the direction of technical support.

These CDs are intended only for recovering from a disaster. They are not needed for initial installation and configuration of the Cluster Platform 4500/3 management server.

Before You Begin Recovery

Before you attempt to restore the management software environment, you must know your system configuration information and the state of your system backups. See TABLE 2-1on page 8 for information on your customized configuration.

Your system configuration information must include the following:

System name

IP address

Time zone

Name service

Subnet information

42 Cluster Platform 4500/3 User’s Guide • July 2001

Page 54
Image 54
Sun Microsystems manual Cluster Platform 4500/3 Recovery, Before You Begin Recovery