SUPER MICRO Computer 6015B-8+ manual Intel HostRAID Configurations, Intel Matrix Storage

SUPERSERVER 6015B-T+/6015B-8+ Manual

The Intel HostRAID Configurations

The following types of Intel's HostRAID confi gurations are supported:

RAID 0 (Data Striping): this writes data in parallel, interleaved ("striped") sections of two hard drives. Data transfer rate is doubled over using a single disk.

RAID1 (Data Mirroring): an identical data image from one drive is copied to another drive. The second drive must be the same size or larger than the fi rst drive.

RAID 10 (Striping & Mirroring): RAID 0 and 1 schemes are combined (without parity information) to get the benefi ts of both.

RAID 5: both data and parity information are striped and mirrored across three or more hard drives.

The Intel Matrix Storage

The Intel Matrix Storage, supported by the ESB2, allows the user to create RAID 0, RAID 1, RAID 10 and RAID 5 sets by using only six identical hard disk drives. The Intel Matrix Storage Technology creates two partitions on each hard disk drive and generate a virtual RAID 0, RAID 1, RAID 10 and RAID 5 sets. It also allows you the change the HDD partition size without any data.

Configuring BIOS settings for SATA RAID Functions (Native Mode)

1. Press the <Del> key during system bootup to enter the BIOS Setup Utility.

Note: If it is the fi rst time powering on the system, we recommend you load the Optimized Default Settings. If you have already done so, please skip to Step 3.

2.Use the arrow keys to select the "Exit" Settings. Once in the "Exit" settings, Scroll down to select "Load Optimized Default Settings" and press the <Enter> key. Select "OK" to confi rm the selection. Press the <Enter> key to load the default settings for the BIOS.

3.Use the arrow keys to select the "Main" section in BIOS.

4.Scroll down to "SATA Controller Mode" and press the <Enter> key to select "Enhanced"

5.Scroll down to "SATA RAID Enabled" and press <Enter>. Then, select "En- abled."

6.Scroll down to "Exit". Select "Save and Exit" from the "Exit" menu. Press the <Enter> key to save the changes and exit the BIOS.

7.Once you've exited the BIOS Utility, the system will re-boot.

8.During the system boot-up, press the <Ctrl> and <I> keys simultaneously to run the Intel RAID Confi guration Utility when prompted by the following message: Press <Ctrl> <I> for the Intel RAID Confi guration Utility.

C-2