Chapter 5: Advanced Serverboard Setup

VGA Enable/Disable

JPG1 allows you to enable or disable the VGA port. The default position is on pins 1 and 2 to enable VGA. See the table on the right for jumper set- tings.

SCSI Controller Enable/ Disable (6015B-8+ only)

Jumper JPA1 is used to enable or dis- able the onboard SCSI controller. The default setting is on pins 1-2 to enable SCSI. See the table on the right for jumper settings.

SCSI Termination Enable/ Disable (6015B-8+ only)

Jumpers JPA2/JPA3 are used to en- able or disable termination for the SCSI Channel A (JPA2) and Channel B (JPA3) connectors. The default setting is open to enable termination. See the table on the right for jumper settings.

Note: In order for the SCSI drives to function properly, please do not change the default setting (enabled) set by the

manufacturer.

VGA Enable/Disable

Jumper Settings (JPG1)

Jumper Setting

Defi nition

Pins 1-2

Enabled

Pins 2-3

Disabled

 

 

SCSI Enable/Disable

Jumper Settings (JPA1)

Both Jumpers

Defi nition

Pins 1-2

Enabled

Pins 2-3

Disabled

 

 

SCSI Term. Enable/Disable Jumper Settings (JPA2/JPA3)

Jumper Setting

Defi nition

Open

Enabled

Closed

Disabled

 

 

5-21

Page 55
Image 55
SUPER MICRO Computer manual VGA Enable/Disable, Scsi Controller Enable/ Disable 6015B-8+ only