SUPER MICRO Computer C2SBE, C2SBA+II user manual

C2SBA+II/C2SBA+/C2SBA/C2SBE User's Manual

To configure the Adaptec SATA RAID for Operating Systems that support RAID functions(--Windows, Red Hat & SuSe, Linux)

1. Press the <Del> key during system bootup to enter the BIOS Setup Utility.

Note: If it is the first time powering on the system, we recommend you load the Optimized Default Settings. If you have already done so, please skip to Step 3.

2.Use the arrow keys to select the "Exit" Settings. Once in the "Exit" settings,

Scroll down to select "Load Optimized Default Settings" and press the <Enter> key. Select "OK" to confirm the selection. Press the <Enter> key to load the default settings for the BIOS.

3.Use the arrow keys to select the "Main" section in BIOS.

4.Scroll down to "SATA Control Mode" and press the <Enter> key to select

"Enhanced"

5.Scroll down to "SATA RAID Enabled" and press <Enter>. Then, select "En- abled."

6.Scroll down to "ICH RAID Codebase" and select "Adaptec". Then press <En- ter>. (For ICH RAID Codebase: Change the setting from Intel to Adaptec.)

7.Scroll down to "Exit". Select "Exit Saving Changes" from the "Exit" menu. Press the <Enter> key to save the changes and exit the BIOS.

8.Once you've exited the BIOS Utility, the system will re-boot.

9.During the system boot-up, press the <Ctrl> and <A> keys simultaneously to run the Intel RAID Configuration Utility when prompted by the following message: Press <Ctrl> <A> for Intel RAID Configuration Utility.

D-2