SUPER MICRO Computer C2SBA+II, C2SBE user manual Front Panel Audio Control, Power LED

C2SBA+II/C2SBA+/C2SBA/C2SBE User's Manual

Front Panel Audio Control

When front panel headphones are plugged in, the back panel audio output is disabled. This is done through the FP Audio header (J12). If the front panel interface card is not connected to the front panel audio header, jumpers should be installed on the header (J12) pin pairs: 1-2, 5-6, and 9-10. If these jumpers are not installed, the back panel line out connector will be disabled and microphone input Pin 1 will be left floating, which can lead to excessive back panel microphone noise and cross talk. See the table below for pin definitions.

High Definition Front Panel Audio Pins# Signal

0,&B/

$8'B*1'

0,&B5

)3B$XGLR'HWHFW

/LQHBB5

3XOOGRZQWR*URXQG

)3B-DFN'HWHFW

.H\

/LQHBB/

 3XOOGRZQWR*URXQG

Power LED

The Power LED connector is designated JLED. This connection is used to provide LED Indication of power supplied to the system. See the table on the right for pin definitions.

PWR LED

Pin Definitions

Pin# Definition

1+5V

2Key

3Ground

KB/MOUSE	JKB
COM1
VGA	Parallel Port
USB 3/4/5/6
USB 1/2	LAN

	CPU Fan
4-Pin PWR	FAN1
	Processor
	DIMM1A
	Intel G33

JPUSB1

Audio	Fan5
	North Bridge
	Slot7 PCI-E x1

FAN2

DIMM2A DIMM1B

	S I/O W83627DHG
DIMM2B	24-pin ATX PWR
	Floppy

A. Front Panel Audio

B. PWR LED

C2SBA

Slot6 PCI-E x16

GLAN CTRL
	Slot5	PCI-E x4		JBT1
		JI2C1	JWOR	JPL1
		JI2C2			Intel ICH9(R)
Audio CTRL
JP5	Audio Enabled	Slot4 PCI-33MHz			South Bridge
CD-IN		Slot3 PCI-33MHz		JP2	BIOS
A		Slot2 PCI-33MHz			IDE CTRL
Front Audio				Speaker
					ITE 8212 JPUSB2
	COM2	Slot1 PCI-33MHz		Buzzer
				SPKR1	WOL

			Battery
	I-SATA2		JP3	B
			JWD
	I-SATA3		JLED
	I-SATA0		I-SATA4	FAN3
				FAN4
	I-SATA1		I-SATA5	CTRL
			LE1
FP USB 7/8	FP USB 9/10			Panel
				Front
				JL1
Front-Access USB 12		Front-Access USB 11
	IDE#2
	IDE#1

2-20