Symantec 5 manual Setting up the hardware, See Adding a license key on

122Adding and removing cluster nodes Adding a node to a cluster

Table 7-1	Tasks that are involved in adding a node to a cluster (continued)
Task		Reference
Install the software		See “Preparing for a manual installation when adding a node”
manually.		on page 123.
		See “Installing VCS RPMs for a manual installation”
		on page 124.
Add a license key.		See “Adding a license key” on page 125.

For a cluster that is running in secure mode, verify the existing security setup on the node.

Configure LLT and GAB.

See “Setting up the node to run in secure mode” on page 126.

See “Configuring LLT and GAB” on page 128.

Add the node to the existing cluster.

Start VCS and verify the cluster.

See “Adding the node to the existing cluster” on page 130.

See “Starting VCS and verifying the cluster” on page 131.

Setting up the hardware

Figure 7-1shows that before you configure a new system on an existing cluster, you must physically add the system to the cluster.