Symantec 5 manual Installing VCS using installonly option, Configuring VCS using configure option

		Installing and configuring VCS 59
		About the VCS installation program
Table 4-2	installvcs options (continued)
Option and Syntax		Description
-rsh		Specifies that rsh and rcp are to be used for communication
		between systems instead of ssh and scp. This option requires
		that systems be preconfigured such that rsh commands
		between systems execute without prompting for passwords
		or confirmations
-security		Enable or disable Symantec Product Authentication Service
		in a VCS cluster that is running. Install and configure Root
		Broker for Symantec Product Authentication Service.
		See “About Symantec Product Authentication Service (AT)”
		on page 19.
-serial		Performs the installation, uninstallation, start, and stop
		operations on the systems in a serial fashion. By default, the
		installer performs these operations simultaneously on all the
		systems.
-timeout		Specifies the timeout value (in seconds) for each command
		that the installer issues during the installation. The default
		timeout value is set to 600 seconds.
-tmppath tmp_path		Specifies that tmp_path is the working directory for installvcs
		program. This path is different from the /var/tmp path. This
		destination is where initial logging is performed and where
		RPMs are copied on remote systems before installation.
-verbose		Displays the details when the installer installs the RPMs. By
		default, the installer displays only a progress bar during the
		RPMs installation.

Installing VCS using installonly option

In certain situations, users may choose to install the VCS RPMs on a system before they are ready for cluster configuration. During such situations, the installvcs -installonlyoption can be used. The installation program licenses and installs VCS RPMs on the systems that you enter without creating any VCS configuration files.

Configuring VCS using configure option

If you installed VCS and did not choose to configure VCS immediately, use the installvcs -configureoption. You can configure VCS when you are ready for