Installing and configuring VCS 77

Installing and configuring VCS 5.0 RU3

CPI WARNING V-9-122-1021

No PERSISTENT_NAME set for NIC with MAC address

00:11:43:33:17:28 (present name eth0), though config file exists! CPI WARNING V-9-122-1022

No config file for NIC with MAC address 00:11:43:33:17:29 (present name eth1) found!

CPI WARNING V-9-122-1022

No config file for NIC with MAC address 00:04:23:ac:25:1f (present name eth3) found!

PERSISTENT_NAME is not set for all the NICs.

You need to set them manually before the next reboot.

Set the PERSISTENT_NAME for all the NICs.

Warning: If the installer finds the network interface name to be different from the name in the configuration file, then the installer exits.

Starting VCS

You can now start VCS and its components on each system. If you chose to configure the cluster in secure mode, the installer also starts the Authentication Service processes on each node in the cluster.

To start VCS

Confirm to start VCS and its components on each node. Enter y if you want to start VCS.

Do you want to start Veritas Cluster Server processes now? [y,n,q] (y) n

Completing the installation

After VCS 5.0 RU3 installation completes successfully, the installer creates summary, log, and response files. The files provide the useful information that can assist you with the installation and can also assist future installations.

Review the location of the installation log files, summary file, and response file that the installer displays.

Table 4-4specifies the files that are created at the end of the installation.

Page 77
Image 77
Symantec 5 manual Starting VCS, Completing the installation, Set the Persistentname for all the NICs