Symantec 5 manual Configuring the cluster in secure mode

Installing and configuring VCS 69

Installing and configuring VCS 5.0 RU3

5Choose whether to use the same NIC details to configure private heartbeat links on other systems.

Are you using the same NICs for private heartbeat links on all systems? [y,n,q,b,?] (y)

If you want to use the NIC details that you entered for galaxy, make sure the same NICs are available on each system. Then, enter y at the prompt.

If the NIC device names are different on some of the systems, enter n. Provide the NIC details for each system as the program prompts.

6Verify and confirm the information that the installer summarizes.

Configuring the cluster in secure mode

If you want to configure the cluster in secure mode, make sure that you meet the prerequisites for secure cluster configuration.

The installvcs program provides different configuration modes to configure a secure cluster. Make sure that you completed the pre-configuration tasks for the configuration mode that you want to choose.

See “Preparing to configure the clusters in secure mode” on page 29.

To configure the cluster in secure mode

1Choose whether to configure VCS to use Symantec Product Authentication Service.

Would you like to configure VCS to use Symantec Security Services? [y,n,q] (n) y

■If you want to configure the cluster in secure mode, make sure you meet the prerequisites and enter y.

■If you do not want to configure the cluster in secure mode, enter n. You must add VCS users when the configuration program prompts. See “Adding VCS users” on page 71.

2Select one of the options to enable security.

Select the Security option you would like to perform [1-3,q,?]

Review the following configuration modes. Based on the configuration that you want to use, enter one of the following values: