TC electronic SDN BHD 48 All Channels, 7Channel name - editable, 9Clip LED RED, 10Channel inserts

CONTROL PANEL - MIXER PAGE

These are the options

Nothing connected Mic/XLR Inst./jack

7Channel name - editable

This is the name of the mixer channel. Click once on the name using the mouse to edit the name.

All Channels

8Input Level meters & +4 dBu/-10 dBv sensitivity The meters indicate the level of the signal present on the input channels. Best signal to noise ratio is achieved when the input signal only occasionally peaks at “0”. Adjust the level on the sending device while watching the meters.

You can toggle between a -10 dBv/+4 dBu sensitivity for line input channels by pressing:

9Clip LED (RED)

When the Clip LED is lit the signal is too hot. Reduce the level on the sending device to compensate.

10Channel inserts

Via the small drop down menu just below the channel meter you can insert one of the two Fabrik C channel strips or none.

11Sends

Each channel has three sends. One for the Fabrik R reverb and one for each of the two AUX sends. Each send can be set as a pre or post fader send.

The routing of the sends is set up on the Setup page.

12Pan/Balance

Fader for for left/right panning.

Press Ctrl+Shift and left mouse button to center.

13Mute/Solo

Press M to mute the channel output and S for soloing this channel.

14Channel Fader

Fader for the output of the channel.

15Fader assign - Studio remote control symbol Some channels and functions are by default assigned to the Studio Kontrol remote. However, any channel added with the “Add Channel” function will appear with the remote control symbol. By pressing this symbol you are allowed to assign this channel to remote buttons 1-6 when the remote is in shift mode.

Press the remote symbol to access the drop down menu and select between Remote Button 1 to 6.

16Channel pair link/unlink

Press to link/unlink channels pairs. (see example on the following page)

12