SETUP PAGE
DAW
In this section you route the outputs of your DAW.
DSP
The DSP outputs are: Main, AUX1, AUX 2 outputs and Fabrik R sends. The AUX outputs are typically used for headphones.
Speaker Sets
Three speaker setups can be setup and switching between the sets is easy. The speaker setups A, B and C can be individually labeled according to your specific application.
8Speaker or Line level ?
In the speaker section you select whether the signal is routed to a speaker or directly to a line output at max level. If this box is checked the level can be controlled by the master level of the remote control. If not, line is sent to outputs regardless of the master level setting.
IMPORTANT !
If a source signal is NOT assigned to a speaker set, you can check “DIRECT” and thus route the signal directly to the mains out at FULL VOLUME.
If you e.g. have active monitors connected to the outputs and these set at full volume, then sending a signal, also at full volume, may damage the speakers.
A
9Assigned to
Indicates which speaker set or sets the source is assigned to.
19
