TC electronic SDN BHD 48 Additional parameters, In/Out, Meters, Kill Dry - Kill wet, Bypass

FABRIK R STUDIO

Additional parameters

Bypass

Bypass function for the entire plug-in.

In/Out
In level Range	: -24 to 0 dB
Out level Range	: -24 to +12 dB

Sets the Input/Output levels for the algorithm. If the Internal overload indicators “O/L” are lit, you may need to readjust the In/Out levels.

Meters

In and output meters. For best performance the In meter should show as close to 0 dB as possible without clipping.

Kill Dry - Kill wet

A reverb can be used either as an insert effect or as a send effect.

Most often it is used as a send effect on a bus. The bus is fed from the channels you apply the effect to. When used as a send effect the Kill Dry should be set to “on” and this is also the default setting. When used as an insert channel, dry signal is necessary and Kill Dry should be set to “off”.

Routing modes

Two routing modes can be selected via the Routing mode drop-down menu.

Plug-In mode - must be selected when Fabrik R Studio is used as VST plug-in.

Internal mode - Use internal mode when Fabrik R is used without a host program with VST facilities.

Example:

Using Plug-In mode in a recording situation will add a slight delay on the reverb. The delay length is depending on the selected Buffer Size (set on the System Settings page). However, as the reverb is used as a send effect, unlike Fabrik C which processes the entire signal, you will most likely not notice that delay in a recording situation on the Reverb. Therefore we suggest using the Plug-In mode for Fabrik R in both recording and mixing.

57