TC electronic SDN BHD 48 Filter, Output, Instance name, Cutoff, Resonance, Type & Slope, Damp

RESONANCE FILTER

Instance name

As several instances of the ResFilter can be opened at the same time you may find it useful to name each instance. Place the cursor and type in your preferred name.

Filter

Cutoff

Sets the cutoff frequency for the selected filter type (Lo-Cut or Hi-Cut).

Resonance

A resonance filer boosts frequencies just prior to the selected Low or Hi-Cut filter. The higher the setting, the more pronounced the filter effect. The resonance is set in percent.

Beware that extreme settings at loud levels may damage your speakers.

Type & Slope

Select between Lo or Hi-Cut filter types. The steepness of the curve is set by the “Slope” parameter. Select between 6, 12 or 24 dB slope. The higher the dB the steeper the slope:

6 dB slope 24 dB Slope

Output

The SoftSat section provides more drive for the resonance filters output, allowing you to create a warm-sounding “analog” distortion.

Softsat on/off

On/off switch for the Softsat section.

Damp

On/off for the hi-frequency attenuation.

Mute

ResFilter mute. In mute mode the source signal is still passed to the output.

Drive

Range: -100 to 100

Sets the amount of drive for the soft-saturation.

Output

Range: -100 to 100

Sets the output level.

61