SETUP PAGE
14 Bass Management
For bass management to be active a few conditions must be setup:
-main channels must be assigned:
-for bass management of the main channels to be active, mark the bass
-a subwoofer is connected to “line out 8” and thus any LFE channel should be routed to this output by setting Assign to “Sub”.
15X-OVER
Sets the
16 + 17 High Pass & Low Pass
The high/low pass filters filtrate the signal before distribution to main and
The
-“off” - no
-“12 dB/octave” for a 12 dB slope above the X- over point
-“24 dB/octave” for a 12 dB slope above the X- over point
The
- “12 dB/octave” for a 12 dB slope below the X- over point
- “24 dB/octave” for a 24 dB slope below the X- over point
18Levels
Individual level adjustment for the LFE channel and the extracted signal below the
21