Introduction | Printed circuit boards |
The instructions given in this section are restricted to those modules which can be replaced at the first line level. After a printed circuit board has been replaced it is sometimes necessary to carry out adjustments to match the new boards to your camera and so maintain the performance levels. The relevant adjustment procedures are referenced in section 4.
The procedures for removing the modules should be followed in reverse order when remounting the units.
To remove a printed circuit board proceed as follows:
a.Open the side cover (see section 2).
b.Swing the black cover 1 of the printed circuit board open.
c.Pull horizontally on this cover to free the board from its connector and slide it clear of the camera.
1 |
Technical Manual LDK 20(S) - Studio Camera | Replacements |
