1800129550 GV93XX-GV94XX E0 A11_110x154 12/03/13 13:52 Page75
Caution: this operation must not be performed until the generator has been unplugged for at least two hours and has completely cooled down. When performing this operation, the generator should be placed near a sink as water may flow out of the tank when it is opened.
•Once the generator has cooled down completely, remove the
•Unscrew the
•To clean the valve properly, just rinse it under running water to remove the scale it contains - fig.21.
•Put the valve back into its housing and screw it in completely to keep it watertight - fig.22.
•Put the cap back on.
•In addition to this regular maintenance, we recommend complete rinsing of the tank every six months or after every 25 uses. To do this:
•Check that the steam generator is cold and has been unplugged for more than 2 hours.
•Place the steam generator on the edge of the sink and put the iron standing upright alongside it.
•Remove the collector cover and unscrew the scale collector.
•Hold your steam generator at an angle and use a jug to fill the boiler with with 1/4 litre of tap water.
•Shake the case for a few seconds then empty it completely into the sink.
•Fit the collector back in its housing and screw it on tightly to ensure it is watertight.
•Put the scale collector cover back in place.
The next time you use your iron, press the “reset” button on the control panel to turn off the orange
“Auto off” System
•For your safety, the generator is equipped with an “auto off” system which switches the generator to standby mode if it is not used for 8 minutes or if you forget to turn it off.
•A red light blinks on the control panel to indicate that the appliance is in standby mode - fig.16.
•To reactivate the generator:
-Press the "Restart" button or push the steam control trigger.
-Wait for the light on the “steam ready” button to stop blinking before your start ironing again.
• If the steam trigger is not pressed for at least 8 minutes, the “auto off” system will cut off your generator for your safety.
DE
EN
FR
NL
IT
DA
NO
SV
FI
TR
EL
PL
Storing your generator
•Place the iron on the iron rest of the generator.
•Press the illuminated on/off switch and unplug the generator.
•Pull the cover over the iron until the protection system automatically locks (you will hear a “click”)
•Store the steam cord in its slide storage place. Take it, fold it in two so as to make a loop. Put the end of this loop in the slide storage place then push gently until you see the end on the other side of the slide storage place – fig.26.
•Fold the Ultracord system back on the heel - fig.8.
•Leave the iron (and the iron rest) to cool down for 1 hour.
•You can then put your steam generator away, carrying it by the handle of the iron.
Environment protection first !
Your appliance contains valuable materials which can be recovered or recycled. Leave it at a local civic waste disposal centre.
CS
SK
HU
RU
UK
ET
LT
LV
75
