Teledyne API T803 CO2/O2 Analyzer Operation Manual Basic Operation
61

4.4. SETUP MODE

The SETUP mode is used to configure the analyzer’s hardware and software

features, perform diagnostic procedures, gather information on the instrument’s

performance and configure or access data from the internal data acquisition

system (DAS).

Note Any changes made to a variable during one of the SETUP procedures are not
acknowledged by the instrument until the ENTR button is pressed. If the EXIT
button is pressed before the ENTR button, the analyzer will beep to notify the
user that the newly entered value has been lost.

For a visual representation of the software menu trees, refer to Appendix A-1.

The areas accessible under the SETUP mode are shown below:

Table 6-4: Primary Setup Mode Features and Functions
MODE OR FEATURE MENU
ITEM DESCRIPTION MANUAL
SECTION
Analyzer Configuration CFG Lists key hardware and software configuration information 5.1
Auto Cal Feature ACAL (Special configuration; consult factory).
Internal Data Acquisition
(DAS) DAS Used to set up the DAS system and view recorded data 7.1
Analog Output Reporting
Range Configuration RNGE Used to configure the output signals generated by the
instruments Analog outputs. 5.2
Calibration Password
Security PASS Turns the calibration password feature ON/OFF 5.5
Internal Clock Configuration CLK Used to Set or adjust the instrument’s internal clock 5.6
Advanced SETUP features MORE This button accesses the instrument’s secondary setup
menu
See
Table 6-5
07276B DCN6418