Texas Instruments MSP430x11x1 interrupt vector addresses, Interrupt Source, Interrupt Flag

MSP430x11x1

MIXED SIGNAL MICROCONTROLLER

SLAS241C ± SEPTEMBER 1999 ± REVISED JUNE 2000

interrupt vector addresses

The interrupt vectors and the power-up starting address are located in the memory with an address range of 0FFFFh-0FFE0h. The vector contains the 16-bit address of the appropriate interrupt handler instruction sequence.

INTERRUPT SOURCE	INTERRUPT FLAG	SYSTEM INTERRUPT	WORD ADDRESS	PRIORITY
Power-up, external reset, watchdog	WDTIFG (Note1)	Reset	0FFFEh	15, highest
	KEYV (Note 1)
NMI, oscillator fault, flash memory	NMIIFG (Notes 1 and 4)	(non)-maskable,
	OFIFG (Notes 1 and 4)	(non)-maskable,	0FFFCh	14
access violation
	ACCVIFG (Notes 1 and 4)	(non)-maskable
			0FFFAh	13
			0FFF8h	12
Comparator_A	CAIFG	maskable	0FFF6h	11
Watchdog timer	WDTIFG	maskable	0FFF4h	10
Timer_A	CCIFG0 (Note 2)	maskable	0FFF2h	9
Timer_A	CCIFG1, CCIFG2, TAIFG	maskable	0FFF0h	8
	(Notes 1 and 2)
			0FFEEh	7
			0FFECh	6
			0FFEAh	5
			0FFE8h	4
I/O Port P2 (eight flags ± see Note 3)	P2IFG.0 to P2IFG.7	maskable	0FFE6h	3
	(Notes 1 and 2)
I/O Port P1 (eight flags)	P1IFG.0 to P1IFG.7	maskable	0FFE4h	2
	(Notes 1 and 2)
			0FFE2h	1
			0FFE0h	0, lowest
NOTES: 1. Multiple source flags

2.Interrupt flags are located in the module

3.There are eight Port P2 interrupt flags, but only six Port P2 I/O pins (P2.0±5) are implemented on the 11x1 devices.

4.(non)-maskable: the individual interrupt enable bit can disable an interrupt event, but the general interrupt enable cannot.

Nonmaskable: neither the individual nor the general interrupt enable bit will disable an interrupt event.

POST OFFICE BOX 655303 •DALLAS, TEXAS 75265 7