70
TRANSMISSION RESERVATION
When your fax is busy receiving an original or transmitting an original from memory, you can "reserve" a
transmission by setting the original (either in the ADF/RADF or on the document glass), reading it into memory, and
entering the fax number. Once the current operation is completed, your fax will automatically dial the number and
transmit the original saving you from having to wait.
When Using the ADF/RADF:
1Confirm that there are no originals on
the document glass and that copying
is not in progress, then gently close
the ADF/RADF.
2Adjust the original guides to the width
of your original.
3Place the original face up and push it
gently into the ADF/RADF. The top
edge of the original should enter the
fax first.
Adjust the resolution
and/or contrast settings if
desired.
4Enter the number of the receiving
machine using one of the following
methods:
• Press a Rapid key.
If you press a Rapid Key, the next step is not
necessary.
The number will be dialed once the current
operation is completed, and transmission will
begin once the connection is made.
• Press the [SPEED/SEARCH] key and enter a
Speed Dial number.
• Enter a full number with the numeric keys.
5Press the [START] key ( ) if you
entered a Speed Dial number or a full
number.
• The number will be dialed once the current
operation is completed, and transmission will
begin once the connection is made.
When placing the Original on the Table:
1Confirm that there are no original(s) in
the ADF/RADF, and open the
ADF/RADF.
2Place the original face down on the
document glass. Align the original
according to the original scale in the
illustration below. (Line up the center
of the edge of the original with the
( ) mark.)
3Gently close the ADF/RADF.
4If needed, set the original size,
resolution, and contrast. (See
"DIALING AND TRANSMITTING"
(p.59))
5Press the [START] key ( ) to scan
the page into memory. If you have
more than one original to read into
memory, place the next page, and
press the [START] key ( ) to read
each page.
6Press the [#] key.
Original face up
When using the document glass, do not set
original(s) in the ADF/RADF.
mark
Original
scale
Note