4 SETUP FLOW

32 Default Setting Check

Default Setting Check

This section describes the items to be set before using this equipment through a network. Check

if the following setups have been done:

Item Description/Reference

Setting the department code The department codes must be set to enable a network printing on a
department basis.
Reference:Operator’s Manual for Copying Functions
Chapter 5 “CHANGING EQUIPMENT’S SETTINGS”
“Department Code”
Setting the paper size for
each drawer
Check if the paper size of each drawer of this equipment is specified
prior to network printing.
Reference:Operator’s Manual for Copying Functions
Chapter 5 “CHANGING EQUIPMENT’S SETTINGS”
“Paper Size Setting”
Setting the device settings Check if the device settings are made prior to network printing.
Reference:Setup Guide for Printing Functions
Chapter 10 “TopAccess ADMINISTRATION TAB PAGE-
SETUP MENU”
“Setting up Device Settings”
“Setting the device settings”
Setting the terminal ID If the Fax Kit is installed, specify the terminal ID to identify the Fax termi-
nal information.
Reference:Operator’s Manual for Facsimile Functions
Chapter 5 "ENTERING VARIOUS FUNCTIONS"(??)
“Terminal ID Entry”