Toshiba EO1-33027E, CB-426-T3-QQ owner manual Measure width of the media that will be loaded

Chapter 2 Printer Installation

2.5Loading the Media (Cont.)

CAUTION!

Do not push into the Supply Roll Holder (inside) with the claw locked in the notches, as this may cause damage to the claw or notches.

See Section 2.5.1 for more detail.

6Turn the Supply Shaft so that the notches face upward, and the marks face the Media Inlet.

7To attach the Supply Roll Holder (inside), fit the tooth of the Supply Roll Holder to the groove of the Supply Roll Shaft. Turn the Supply Roll Holder clockwise to the end.

Notches Groove

Supply Roll Holder

Claw

Marks	Tooth
Supply Shaft	Claw

Supply Roll Holder

8Push the Supply Roll Holder (inside) to the end of the Supply Shaft. Then turn the Supply Roll Holder counterclockwise so that the claw is locked into the notch. When inserting the Supply Roll Holder into the Supply Shaft, more pressure should be applied when passing over the roller on the way to the end of the Supply Shaft.

Claw

Notches

Marks

Note:

The media is rolled either outside or inside, depending on the type of media that is loaded. Whichever media is used, load it with print side facing up. See Appendix 1 for more detail.

9Switch the Back Tension Selector, depending on whether the media is rolled outside or inside. Switch the Selector to A for the media rolled outside. Switch it to B for the media rolled inside, as indicated by the arrows.

Back Tension Selector

A

Media rolled outside

Media rolled inside

B

Supply Shaft Holder

10Measure width of the media that will be loaded.

12