Programming the remote control for use with your audio/video devices
Device code setup
1.Refer to tile Device code table on pages
tf more than one number is listed, try each one separately until you find the one that works.
2.Press MODE until the Mode indicator of the device (CABLE/ SAT, VCR, DVD, AUDIO1, AUD102) lights up.
3.While holding down the RECALL button, press the Channel
Number buttons to enter the
one long blink.
4.Point the remote control at the device and press POWER to test the code.
tf the device turns on, you have entered the correct code.
tf the device does not respond to the remote control, you may
have entered the wrong code. Repeat steps 3 and 4 using another
code.
5. Press MODE to select the TV mode to control the TV.
Searching and sampling the code of a device [8500}
If you do not know the device code for a particular target unit, you can cycle the remote control through the available codes for that device mode and sample the functions to find the code that properly operates the target device. The keys available to be sampled, provided they are applicable to that mode, are POWER, 1, VOL A, CH A, and PLAY. Invalid keys will be ignored while in program mode.
To cycle through each available device code and sample its functions:
1.Press MODE to select the mode you want to set up.
2.While holding down the RECALL button, press 8
3.Point the remote control at the target device and press POWER (or other function buttons that are available to be sampled).
4.tfthe device responds to the remote control:
Press RECALL to store the device code.
The mode indicator will blink twice and the remote control will exit the program mode.
tf the device does not respond to the remote control: Press A, and then press POWER.
Repeat this step until the device responds to the remote control, and then press RECALL.
Note: When a search cycleis completed, the mode indicator will blink three times 7heremote control will begin to cycle through the availablecodesagain ff no key is pressed within tOseconds while programming, the remote control will exit the program mode and return to the previous code
Note:
•Everytime you replace the batteries,you must reprogram the remote con_oL
•Some newer VCRsare capable ofworking on either of two remote codes TheseVCRs havea switch labeled "VCRI/VCR2."
ffyour VCRhas thiskind of switch and does not respond to any of the codes for your VCR brand,set the switch to the other
position (VCRI or VCR2)and reprogram the remote con_ol
22
