Memory expansion, Installing memory module | Toshiba TE2000 instruction

User’s Manual

OPTIONAL DEVICES

PC CARD

EJECT BUTTON

Figure 8-3 Removing the PC card

Memory expansion

You can install additional memory in the computer’s memory module to increase the amount of RAM.

128,256 or 512MB memory modules can be installed in the two memory slots for a maximum of 1GB system memory.

CAUTION: Only memory modules with the following parts numbers can be installed:

PA3085U-1M12:	128 MB
PA3086U-1M25:	256MB
PA3108U-1M51:	512 MB

CAUTION: Windows 98 does not support more then 512MB of memory and will not operate, if more then 512MB is installed.

Installing memory module

To install a memory module, make sure the computer is in boot mode then:

1.Turn the computer off in boot mode. Refer to the Turning off the power section in Chapter 3.

CAUTIONS: 1. Do not try to install a memory module with the computer turned on or turned off in Standby and Hibernation mode. You can damage the computer and the module.

8-4

Image 161

Toshiba TE2000 manual Memory expansion, Installing memory module

Contents

Portable Personal Computer User’s Manual Toshiba TE2000 Trademarks CopyrightDisclaimer Conformity Statement Modem warning noticeVcci Class B Information Japan regulations Network Compatibility StatementRegion selection Redial Pursuant to FCC CFR 47, Part Type of serviceTelephone company procedures Instructions for IC CS-03 certified equipment If problems ariseDisconnection Fax brandingPage AT&F AT&W AT%TE=0 ATZ Modem warning notice for Australia Any 30 minute period for any single manual call initiation, General conditions Wireless Interoperability Information to Wireless LAN UserWireless LAN and your Health Regulatory Information Europe EU Declaration of Conformity Canada Industry Canada IC Et 11 2462 MHz Interference Statement USA-Federal Communications CommissionFCC Taiwan Using this equipment in JapanPage Device Authorization Electronic communication device authorizationRegulatory statements General FCC Interference Statement United States of America and CanadaCanada IC Notice Page Location of the required label Toshiba DVD-ROM drive SD-C2502** safety instruction Stråling Matsushita CD-R/RW drive UJDA340** safety instruction Locationofofthetherequiredlabellabel Stråling Locationion of the required label of the required label Matsushita CD-RW/DVD-ROM drive UJDA720** safety instruction To EN60825 Toshiba CD-RW/DVD-ROM drive SD-R2102** safety instruction Location of the required label Stråling Teac DVD-ROM drive DV-28E** safety instruction To EN60825 Teac CD-ROM drive CD-224E** safety instruction Location of the required label NÅR SIKKERHEDSAF-BRYDER ER Teac CD-R/RW drive CD-W28E** safety instruction Location of the required label Stråling 26-5, Toranomon 1-CHOME, MINATO-KU, Tokyo Japan Hitachi DVD-ROM drive GDR-8081N** safety instruction To EN60825 Page Table of Contents Xlii Getting StartedOperating Basics Keyboard Power and Power-Up ModesPower conditions Xliii Xliv HW Setup and PasswordsOptional Devices Xlv Troubleshooting Glossary Index Appendixes Preface Manual contents Abbreviations ConventionsIcons Keys Display Key operationMessages XlixPage Stress injury Heat injury General PrecautionsPressure or impact damage PC card overheating Lii Chapter Equipment checklistIntroduction Windows XP Windows 2000 Service Pack Processor FeaturesFeatures Disks Memory Keyboard Display Ports PowerAccuPoint Communications SlotsMultimedia Software Slim Select BaySecurity Special features Special features Utilities Double-click the Mouse icon Utilities Options Slim Select Bay options Options Introduction Front with the display closed Grand Tour Video-out jack PC card slot Left side Right side Right side Back side Underside Underside Grand Tour Front with the display open Front with the display open Power source/system indicators Indicators Indicators Power source/system indicators Keypad overlay indicators Keyboard indicator Slim Select Bay modules AC adaptorSlim Select Bay modules DVD-ROM drive Indicator CD-R/RW drive CD-ROM drive CD-RW/DVD-ROM drive 12 The Slim Select Bay HDD adaptor Slim Select Bay HDD adaptor Weight saver Slim Select Bay 2nd battery pack Getting Started General conditions Setting up your work spacePlacement of computer Posture and positioning of the computer Seating and posture Work habits Lighting Opening the display Connecting the AC adaptor Connect the power cord to the AC adaptor Turning on the power Turning on the power Windows 98 setup Windows XP Professional/2000 setupTurning off the power Shut Down mode Boot mode Benefits of hibernation Hibernation mode Automatic Hibernation Starting Hibernation Benefits of standby Standby modeData save in hibernation mode Standby limitations Restarting the computerExecuting standby Restoring the Windows system Software decompression window Getting Started Operating Basics Using AccuPoint Replacing the cap AccuPoint II precautions Changing Slim Select Bay modules Changing Slim Select Bay modulesRemoving a module Installing a module Using optical media drivesCD-ROM drive DVD-ROM drive Loading CDs Using optical media drivesCD-R/RW drive Read Write Manual release with the eject hole Inserting a CD Closing the drawer Removing CDs 10 Removing a CD CD/DVDs care 11 The 3 1/2 external diskette drive Using 3 1/2 external diskette drive Using 3 1/2 external diskette drive Connecting 3 1/2 diskette drive Diskette care Disconnecting 3 1/2 diskette drive Wireless LAN Wireless communicationsWireless communication switch Wireless communications LED status Indication Wireless communication LED LAN cable types Connecting cable Super Long Life scheme Disconnecting cable 14 The Super Long Life Properties window Network Device Switch Region selection Using the internal modem Properties menu Using the internal modem AutoRun Mode SettingModem Selection Location list for region selection Dialing Properties Connecting Moving the computer Cleaning the computerDisconnecting Heat dispersal Heat dispersal Operating Basics Typewriter keys Keyboard Emulating keys on enhanced keyboard F1 … F12 function keysSoft keys Fn key combinations Soft keys Fn key combinations Hotkeys Soft keys Fn key combinations Keypad overlay Windows special keysEmulating Fn key on external keyboard Fn Sticky key Turning on the overlays Arrow modeNumeric mode Temporarily changing modes Temporarily using normal keyboard overlay onTemporarily using overlay overlay off Generating Ascii characters Keyboard Power conditions Power and Power-Up Modes LED 2nd battery off Power conditions DC in indicator Power indicatorsBattery indicators Power indicator Battery typesMain battery Battery types Real time clock battery Secondary battery option Care and use of the battery pack Care and use of the battery packSafety precautions Battery charging notice ProceduresCharging the batteries Time Monitoring battery capacity Retaining data with power off Maximizing battery operating time Extending battery life Removing the battery pack Replacing the battery pack Replacing the battery pack Installing the battery pack Password = Starting the computer by password Accessing HW Setup HW Setup and PasswordsHW Setup HW setup window Windows XP HW Setup window There are also three buttons OK, Cancel and Apply HW Setup User Password Password Device Configuration Device Config Pointing Devices Parallel/Printer CPU Boot Priority Following order CD-ROM*, LAN, HDD Boot command, then the HDD installed USB Supervisor password Supervisor password Passwords Optional Devices Power devicesCards/memory Peripheral devices User’s Manual Installing a PC cardPC cards PC cards Removing a PC card Memory expansion Installing memory module Removing the cover Memory expansion Seat the cover and secure it with two screws Removing memory module Slim Select Bay 2nd battery pack Additional battery packSlim Select Bay 2nd battery pack Removing Installing Additional AC adaptor Battery chargerSlim Select Bay HDD adaptor Slim Select Bay HDD adaptor 12 Installing the HDD Advanced Port Replicator USB diskette driveAdvanced Port Replicator Parallel printer Set the Parallel Port Mode and press OK External monitor External monitor PS/2 mouse Television PS/2 keyboard PS/2 keyboard 15 Security lock Security lock Preliminary checklist TroubleshootingProblem solving process Analyzing the problem System start-up Hardware and system checklistHardware and system checklist Self test Power Problem Procedure Overheating power downAC power Problem Procedure Battery Password LCD panel Hard disk drive Foreign object in the drawer could block laser DVD-ROM drive Grand Tour ProblemProcedure Diskette drive Printer Infrared port AccuPoint Pointing device PC card Serial mouse ProblemProcedure Monitor Sound system TV output signal USB Modem No Carrier Hibernation LAN Memory expansion Before you call Where to writeToshiba support Europe Germany & Austria Toshiba support Troubleshooting Physical Dimensions SpecificationsPower Requirements Appendix a Network control unit NCU Built-in Modem Appendix B Display Controller and ModesDisplay controller Table Video modes Video modes Appendix B 640 x 64K of 64K 60Hz Grph Pels 75Hz 85Hz Repeat last command AT CommandsAppendix C +++ Escape sequence Dn Dial Bn Communication standard setting Request ID information En Echo commandHn Hook control Nn Modulation handshake Mn Monitor speaker mode Qn Result code control On Return on-line to data modeSelect pulse dialing Xn Result code selection, call progress monitoring Vn DCE response format Busy tone detect Dial tone detectZn Recall stored profile Cn Data Carrier Detect DCD control Dn DTR control Load factory settings Gn V.22bis guard tone control Self-test commandsKn Local flow control selection Select Pulse Dial Make/Break Ratio WW Zn=x Store telephone number Display Current ConfigurationStore current configuration \Qn Local flow control selection Nn\ Error control mode selection Cn Data compression control View numbers in blacklist Ppendixa Register values RegistersAppendix D ATSn? S0 Auto answer ring number S3 Command line termination characterS1 Ring counter S2 AT escape character user defined S6 Wait before dialing S5 Command line editing character user definedS4 Response formatting character user defined S8 Comma pause time S7 Connection completion time-outS11 Dtmf dialing speed S12 Escape guard time S37 Dial line rate Result code summary Result Code Numeric Description AT command set result codes Result Code Numeric Description Appendix D Function Transmission speed ModeAppendix E Table E-1 Result codes for a V.90 connection Appendix E AT Command Appendix E Appendix F Wireless LANAbout Toshiba Wireless solution Peer-to-peer workgroup Figure F-1 Peer-to-peer Wireless workgroup Appendix F Enterprise networking Wireless LAN card features Easy configuration Wireless LAN cards Wireless LAN card typesBasic settings for enterprise networks Click Settings, and then Control Panel Value ANY Set the correct Network Name and Encryption Key Basic settings for peer-to-peer workgroups Using your Wireless LAN card Working with Wireless and WindowsRadio antennas View other computers Entire Network icon Using the Client Manager Icon Description Color View Wireless link quality Figure F-6 Edit Wireless Configuration Settings View/modify Wireless LAN card settings Encryption window Advanced configurations Figure F-8 Advanced window Advanced window Figure F-9 Admin parameters Admin window Storage 10 to 60 C Card specifications Radio characteristics Table F-5 Radio characteristics 2457 Supported frequency sub-bands Appendix G AC Power Cord Connectors Australia Europe USA and Canada Appendix H Installing the modem boardInternal Modem Guide Removing the modem board Appendix Parts Numbers LAN Glossary-1 Glossary Glossary-2 AccuPoint Glossary-3 Byte Glossary-4 Cache memory Glossary-5 Delete Glossary-6 Device driver Glossary-7 Host computer Glossary-8 Hot dock/undock Glossary-9 Modem Glossary-10 Monitor Glossary-11 RAM Glossary-12 Restart Glossary-13 Write protection Glossary-14 Index-1 Index Index-2 Index-3 Index Index-4 Index-5 Index-6