HW Setup
To delete a user password:
1.Select Not Registered to display the following prompt:
Enter Password:
2.Enter the currently registered password. The character string you enter is displayed as a string of asterisks.
Enter Password: ****
NOTE: If you click the OK button before entering the password, Registered will appear on the display.
3.Click the OK button. If the character string you enter matches the registered password, the password option is reset and the display changes to:
Not registered
If they do not match, the following message appears. You must repeat step 1.
Incorrect Password!!!
NOTE: If you enter the password incorrectly three times, the screen will display:
Sorry, access denied!!! Powering off your machine then powering it back on again are required to regain access.
You will not be able to access the password option in the HW Setup. In this case you must turn the power off and back on to retry the procedure.
4.Follow the same procedures described in the earlier section, How to set the password, to set a new user password.
Refer to the Supervisor password section later in this chapter for details on setting the supervisor password.
Device Config
Device Configuration
This option lets you set the device configuration.
All Devices BIOS sets all devices.
Setup by OS Operating system sets devices that it can control.
ASSWORDSP
SHW ETUPAND