Toshiba TE2000 manual Memory expansion, Removing the cover

Memory expansion

2.If you install a memory module that is not compatible with the computer, a beep will sound when you turn on the power. If the module is installed in slot A, there will be a long beep followed by a short beep. If the module is in slot B, there will be a long beep followed by two short beeps. In this case shut down the power and remove the incompatible module.

2.Remove all cables connected to the computer.

3.Turn the computer upside down and remove the battery pack (refer to Chapter 6, Power and Power-Up Modes.)

4.Remove two screws securing the memory module cover.

5.Lift off the cover.

NOTE: Use a point size 0 Phillips screwdriver.

Figure 8-6 Removing the cover

6.Insert the memory module into the connector on the computer. Press the module carefully and firmly to ensure a solid connection.

7.Push the module down so that it lies flat and is secured by two latches.

CAUTION: Do not touch the connectors on the memory module or on the computer. Debris on the connectors may cause memory access problems.

PTIONALO

DEVICES

8-5