TD-W8960N300Mbps Wireless N ADSL2+ Modem Router User Guide

4.Enter the following parameters and then click Next.

Figure 4-10

¾PPP Username/Password: Enter the User Name and Password provided by your ISP. These fields are case-sensitive.

¾PPPoE Service Name: Enter the Service Name if it was provided by your ISP. If you leave it blank, the default name will be the same as the Service Description on the previous screen.

¾Authentication Method: Select the Authentication Method from the drop-down list, the default method is AUTO, and you can leave it as a default setting.

)Note:

If you are not sure about the PPP IP extension and PPP Debug Mode etc. below, please don’t select these options.

¾MTU Size: Maximum Transmission Unit Size. Check this box then you can change the MTU size. The default MTU value is 1480 Bytes. It is not recommended that you change the default value unless required by your ISP.

¾Enable Fullcone NAT: It is a type of NAT, if not enabled, the default NAT will act.

¾Dial on demand (with idle timeout timer): The Router will cut off the Internet connection after it has been inactive for a specific period of time (idle timeout), and it will automatically re-establish the connection as soon as you attempt to access the Internet again. If your Internet is charged by time you may want to select this option in order to save money.

¾PPP IP extension: Select this option to get the public IP address from the PPP server to your

24

Page 31
Image 31
TP-Link manual TD-W8960N 300Mbps Wireless N ADSL2+ Modem Router User Guide