TP-Link TD-W8960N manual ATM-IPoA, ETH-PPPoE, ETH-IPoE, ETH-Bridge

TD-W8960N300Mbps Wireless N ADSL2+ Modem Router User Guide

4.4.2.5 ATM-IPoA

If your ISP provides an IPoA connection and you need to use an ATM Interface, follow the steps below to add a WAN service over a selected ATM interface.

1.Add a new ATM interface and select IPoA option for DSL Link Type (see 4.4.1.1 ATM interface).

2.Click the Add button on the screen Figure 4-7and the next configuration is similar to IPoE (see section 4.4.2.2 ATM-EoA-IPoE). The difference is that you have to manually set the Static IP Address on the screen of Figure 4-15,and the Static IP Address for DNS Server on the screen of Figure 4-18.

)Note:

ETH and ATM service can not coexist. If the ATM Interface had configured, you cannot configure any other WAN service over the ETH Interface until the ATM Interface is deleted.

4.4.2.6 ETH-PPPoE

If your ISP provides a PPPoE connection and you need to use an ETH Interface, follow the steps below to add a WAN service over a selected ETH interface:

1.Add a new ETH interface on the screen of 4.4.1.2 ETH interface.

2.Click the Add button on the screen Figure 4-7and the following configuration is similar to PPPoE over ATM interface (see section 4.4.2.1 ATM-EoA-PPPoE).

4.4.2.7 ETH-IPoE

If your ISP provides an IPoE connection and you want to use an ETH Interface, follow the steps below to add a WAN service over a selected ETH interface:

1.Add a new ETH interface on the screen of 4.4.1.2 ETH interface.

2.Click the Add button on the screen Figure 4-7and the next configuration is similar to IPoE over ATM interface (see section 4.4.2.2 ATM-EoA-IPoE).

4.4.2.8 ETH-Bridge

If you want to adopt the Bridge service and you need to use an ETH Interface, follow the steps below to add a WAN service over a selected ETH interface:

1.Add a new ETH interface on the screen of 4.4.1.2 ETH interface.

2.Click the Add button on the screen Figure 4-7and the next configuration is similar to Bridge over ATM interface (see section 4.4.2.3 ATM-EoA-Bridg).

)Note:

For ETH-PPPoE, ETH-IPoE and ETH-Bridge, the Bridging option will display in the screen of Figure 4-20only when VLAN MUX Mode is selected for Connection Mode on the screen of Figure 4-5.You have to set the 802.1P Priority and 802.1Q VLAN ID.

31