TP-Link TL-WDR3600 manual Quick Installation Guide, TCP/IP Configuration

TL-WDR3600N600 Wireless Dual Band Gigabit Router

Chapter 3. Quick Installation Guide

This chapter will show you how to configure the basic functions of your N600 Wireless Dual Band Gigabit Router using Quick Setup Wizard within minutes.

3.1TCP/IP Configuration

The default IP address of the Router is 192.168.0.1 and the default Subnet Mask is 255.255.255.0. These values can be changed as you desire. In this guide, we use all the default values for description.

Connect the local PC to the Ethernet ports of the Router and then you can configure the IP address for your PC by the following method: Set up the TCP/IP Protocol in "Obtain an IP address automatically" mode on your PC. If you need instructions as to how to do this, please refer to Appendix B: Configuring the PC. Then the built-in DHCP server will assign IP address for the PC.

Now, you can run the Ping command in the command prompt to verify the network connection between your PC and the Router. The following example is in Windows 2000 OS.

Open a command prompt, and type ping 192.168.0.1, and then press Enter.

If the result displayed is similar to the Figure 3-1,it means the connection between your PC and the Router has been established well.

Figure 3-1 Success result of Ping command

If the result displayed is similar to Figure 3-2,it means the connection between your PC and the Router failed.

-9 -