TP-Link TL-WDR3600 manual II. Enter the client device’s PIN on the Router

TL-WDR3600N600 Wireless Dual Band Gigabit Router

Figure 4-17

Figure 4-18 Add A New Device

Step 2: Press and hold the WPS button of the client device directly.

Step 3: The Wi-Fi Protected Setup LED flashes for two minutes during the Wi-Fi Protected Setup process.

Step 4: When the WPS LED is on, the client device has successfully connected to the Router.

Step 5: Refer back to your client device or its documentation for further instructions.

II. Enter the client device’s PIN on the Router

Use this method if your client device does not have the WPS button, but has a Wi-Fi Protected Setup PIN number.

Step 1: Keep the default WPS status as Enabled and click the Add device button in Figure 4-16,then Figure 4-19will appear.

Figure 4-19 Add A New Device

Step 2: Enter the PIN number from the client device in the field on the above WPS screen. Then click Connect button.

Step 3: “Connect successfully” will appear on the screen of Figure 4-19,which means the client device has successfully connected to the Router.

- 37 -