Transcend Information III manual Changing the Settings, Type at the prompt

3-6 CHAPTER 3: CONFIGURING THE ADAPTER

Changing the Settings

To change the software option settings, follow these steps:

1Make sure the 3C592 EISA adapter has been properly installed in your computer.

CAUTION: If this computer is an operating server, notify all users of the server to save their work and log out from the network before you begin. The Configuration and Diagnostic Program disrupts the normal operation of servers and workstations, so work that is not saved may be lost.

2Boot your computer under DOS, version 3.1 or later.

3Place the EtherDisk diskette in a floppy drive on your computer and make that drive the active drive. For example:

A:[Enter]

4Type at the prompt:

INSTALL [Enter]

5The first time you use the EtherDisk diskette, a license screen appears. To accept the terms and conditions of the 3Com end-user software license agreement, type the following:

Y

6When the Auto Installation screen appears, as shown in Figure 3-2, press [Enter].

7When the main menu appears with a list of options, as shown in Figure 3-3, select Configuration/Diagnostic/ Troubleshooting.

8When the Configuration and Diagnostic screen appears, select Configuration and Diagnostic Program.