Loading NetWare ODI Drivers 4-13
Driver Installation with NetWare
To load the 4.x server driver, follow these steps:
1Copy the contents of the appropriate \NETWARE subdirectory to the boot partition of the server’s hard disk.
2When you start the server, enter the following commands:
For NetWare 3.11:
LOAD C:LSLENH.NLM [Enter]
LOAD C:3C59X.LAN PORT=XXXX NAME=X [Enter] LOAD C:3C59X.LAN PORT=XXXX NAME=Y [Enter]
BIND IPX TO X NET=XXXX
BIND IPX TO Y NET=XXXX
For NetWare 3.12, 4.0x, or 4.x:
LOAD C:3C59X.LAN PORT=XXXX NAME=X [Enter] LOAD C:3C59X.LAN PORT=XXXX NAME=Y [Enter]
BIND IPX TO X NET=XXXX
BIND IPX TO Y NET=XXXX
where XXXX is the adapter’s port address and NAME X and Y are names that you assign to help distinguish the multiple adapters. (To determine the port address, refer to the previous section “Finding the Adapter’s Port Address for Multiple Adapters.”)
If the load sequence above is not followed, the system will not operate correctly. Make sure that the PORT XXXX parameter is completed for all adapters.
When running the 3C59X.LAN driver with NetWare 3.11, you must update the MONITOR.NLM file that accompanied NetWare 3.11 with the MONITOR.NLM file from Novell. For the latest NLMs, contact Novell.
