Transition Networks SISPM1040-182D user manual System Event Log, Syslog Configuration

Transition Networks SISPM1040-182D

6.8 System Event Log

This page allows the user to decide whether to send the system event log, and select the mode which the system event log will be sent to client only, server only, or both client and server. What kind of event log will be issued to the client/server depends on the selection on the Event Configuration tab. There are five types of events—Device Cold Start, Device Warm Start, Authentication Failure, X-Ring Topology Change, and Port Event—available to be issued as the event log.

6.8.1 Syslog Configuration

„Syslog Client Mode: Select the system log mode—Client Only, Server Only, or Both. ‘Client Only’ means the system event log will only be sent to this interface of the switch. ‘Server Only’ means the system log will only be sent to the remote system log server with its IP assigned. If the mode is set to ‘Both’, the system event log will be sent to the remote server and this interface.

„System Log Server IP Address: When the ‘Syslog Mode’ item is set as Server Only/Both, the user has to assign the system log server IP address to which the log will be sent.

„Click Reload to refresh the event log displaying area.

„Click

Clear to clear all the current event logs.

„Make sure the selected mode is correct, and click Apply to have the setting take effect.

Technical Support: 1-800-260-1312 International: 00-1-952-941-7600