Tyan Computer B2094T15 warranty Adding a CD Drive for test purpose

6.4Adding a CD Drive (for test purpose)

In case you need to use a CD drive with your system, follow this procedure.

WARNING: You are advised not to make frequent connection and disconnection on the IDE connector as this might cause damage to the data cable and connector pins.

CAUTION: Follow the instructions in this section carefully. The DVD or CD drive contains a laser device. Do not attempt to open the DVD or CD drive’s enclosure or remove a DVD or CD drive using any procedures other than those contained in this section to avoid the risk of exposure to harmful radiation.

With a Secondary Hard Disk Drive Installed

1.Remove the cabinet cover (see section 6.1).

2.Unplug the data cable and power cord from the rear of the secondary hard disk drive. Unplug the other end of the data cable from the secondary IDE connector on the system board.

3.Use the three-heade d power cable that came with your system and connect the single end to the previously unplugged power cord ( Œ) from step 2. Connect the remaining two ends of the power cable, one to the rear of the secondary hard disk drive (•) and the other to the rear of the CD drive (Ž).

Three-headed power cable

4.Use the three-heade d data cable that came with your system and connect the single end to the secondary IDE connector (Œ). Connect the remaining two ends of the data cable, one to the rear of the secondary hard disk drive (•) and the other end to the rear of the CD drive (Ž).

45

http://www.TYAN.com